Opengear ACM5000, User Manual

Page: 247 / 335

Console Server & Router User Manual
247
# config -s config.ports.port5.protocol=RS232
# config -s config.ports.port5.flowcontrol=None
The following command will synchronize the live system with the new configuration:
# config -r serialconfig
Note: Supported serial port baud-
rates are ‘50’, ‘75’, ‘110’, ‘134’, ‘150’, ‘200’, ‘300’, ‘600’,
‘1200’, ‘1800’, ‘2400’, ‘4800’, ‘9600’, '19200', '38400', '57600', '115200', and '230400'.
Supported parity values are 'None', 'Odd', 'Even', 'Mark' and 'Space'.
Supported data-bits values are '8', '7', '6' and '5'.
Supported stop-bits values are '1', '1.5' and '2'.
Supported flow-control values are 'Hardware', 'Software' and 'None'.
Additionally, before any port can function properly, the mode of the port needs to be set. Any port can be set to run in one
of the five possible modes (refer
Chapter 4 for details): [ Console Server mode | Device mode | SDT mode | Terminal
server mode | Serial bridge mode]. All these modes are mutually exclusive.
Console Server mode
The command to set the port in portmanager mode:
# config -s config.ports.port5.mode=portmanager
To set the following optional config elements for this mode:
Data accumulation period 100 ms
Escape character % (default is ~)
log level 2 (default is 0)
Shell power command menu Enabled
RFC2217 access Enabled
Limit pot to 1 connection Enabled
SSH access Enabled
TCP access Enabled
telnet access Disabled
Unauthorized telnet access Disabled
# config -s config.ports.port5.delay=100
# config -s config.ports.port5.escapechar=%
# config -s config.ports.port5.loglevel=2
# config -s config.ports.port5.powermenu=on
# config -s config.ports.port5.rfc2217=on
# config -s config.ports.port5.singleconn=on
# config -s config.ports.port5.ssh=on
# config -s config.ports.port5.tcp=on
# config -d config.ports.port5.telnet
# config -d config.ports.port5.unauthtel
Device Mode
For a device mode port, set the port type to either ups, rpc, or enviro:
# config -s config.ports.port5.device.type=[ups | rpc | enviro]
For port 5 as a UPS port:
# config -s config.ports.port5.mode=reserved
For port 5 as an RPC port:
# config -s config.ports.port5.mode=powerman
For port 5 as an Environmental port:
# config -s config.ports.port5.mode=reserved