Opengear ACM5000, User Manual

Page: 246 / 335

Chapter 14:
Command Line Configuration
246
Console Server & RIM Gateway User Manual
alerts
auth
cascade
console
dhcp
dialin
eventlog
hosts
ipaccess
ipconfig
nagios
power
serialconfig
services
slave
systemsettings
time
ups
users
There are three ways to delete a config element value. The simplest way is use the
delete-node script detailed later in
Chapter 15. You can also assign the config element to "", or delete the entire config node using -d :
# /bin/config -d 'element name'
All passwords are saved in plaintext except the user passwords and the system passwords, which are encrypted.
Note: The config command does not verify whether the nodes edited/added by the user are valid. This means that any
node may be added to the tree. If a user were to run the following command:
# /bin/config -s config.fruit.apple=sweet
The configurator will not complain, but this command is clearly useless. When the configurators are run (to turn
the config.xml file into live config) they will simply ignore this <fruit> node.
Administrators must make sure of the
spelling when typing config commands. Incorrect spelling for a node will not be flagged.
Most configurations made to the XML file will be immediately active. To make sure that all configuration changes are
active, especially when editing user passwords, run all the configurators:
# /bin/config -a
For information on backing up and restoring the configuration file refer Chapter 15 Advanced Configuration .
14.1.1 Serial Port configuration
The first set of configurations that needs to be made to any serial port are the RS232 common settings. For example to
setup serial port 5 to use the following properties:
Baud Rate 9600
Parity
None
Data Bits 8
Stop Bits 1
label Myport
log level 0
protocol RS232
flow control None
To do this use the following commands:
# config -s config.ports.port5.speed=9600
# config -s config.ports.port5.parity=None
# config -s config.ports.port5.charsize=8
# config -s config.ports.port5.stop=1
# config -s config.ports.port5.label=myport
# config -s config.ports.port5.loglevel=0