3. Press ENTER with "Update" selected to start update.
During the update, the TV screen may go black depending on the updated
program. In that case, check the progress on the display of the unit. The TV
screen will remain black until the update is complete and the power is
turned on again.
"Completed!" is displayed when the update is complete.
4. Press ON/STANDBY on the main unit to turn the unit into standby mode. The
process is completed and your firmware is updated to the latest version.
Do not use on the remote controller.
If an Error Message is Displayed
When an error occurs, "
＊
＊＊
Error!" is displayed on the display of the unit. ("
＊
"
represents an alphanumeric character.) Check the following:
Error Code
＊
01,
＊
10
：
Ethernet cable not found. Connect the Ethernet cable properly.
＊
02,
＊
03,
＊
04,
＊
05,
＊
06,
＊
11,
＊
13,
＊
14,
＊
16,
＊
17,
＊
18,
＊
20,
＊
21
：
Internet connection error. Check the following:
– The router is turned on
– This unit and the router are connected via the network
Try to disconnect and then connect again the power to the unit and router. This
may solve the problem. If you are still unable to connect to the Internet, the
DNS server or proxy server may be temporarily down. Check the service status
with your ISP provider.
Others
Disconnect then reconnect the AC power cord, then repeat from the beginning.
