1. Place the supplied speaker setup microphone in the listening position, and
connect to the SETUP MIC jack on the main unit.
When putting the speaker setup microphone on a tripod, refer to the illustration
when putting it in place.
To cancel AccuEQ Room Calibration partway through, disconnect the
speaker setup microphone.
2. Select the connected speaker configuration.
The image on the screen changes as you choose the number of channels in
"Speaker Channels", so refer to it when performing the settings.
Also use this screen to select whether you have connected a subwoofer and to
select the type of height speaker, etc.
If you have connected a subwoofer, check the power and volume of the
subwoofer. Set the subwoofer volume to more than halfway.
3. Test tones are emitted by the speakers, and firstly the unit detects the speakers
connected and the noise in the environment.
4. After the results of the above measurements are displayed, select "Next",
press ENTER on the remote controller, and the test tones are emitted again,
and the unit automatically makes settings such as the optimum volume level
and the crossover frequency.
5. Select whether to enable or disable the equalizer function that corrects for
distortion caused by the acoustic environment of the room.
