Set the maximum value to avoid too high volume. Select a value from "Off",
"50" to "99". (When "Volume Display" is set to "Absolute")
Power On Volume
Default Value: Last
Set the volume level of when the power is turned on. Select a value from
"Last" (Volume level before entering standby mode), "Min", "0.5" to "99.5"
and "Max". (When "Volume Display" is set to "Absolute")
You cannot set a higher value than that of "Maximum Volume".
Headphone Level
Default Value: 0.0 dB
Adjust the output level of the headphones. Select a value between "
－
12.0
dB" and "
＋
12.0 dB".
4. Source
Make settings for input sources, such as volume difference adjustments for each
input selector for the connected equipment.
1. IntelliVolume
Adjust the volume level difference between the devices connected to the unit.
Select the input selector to configure.
IntelliVolume
Default Value: 0.0 dB
Select a value between "
－
12.0 dB" and "
＋
12.0 dB". Set a negative value if
the volume of the target device is larger than the others and a positive value
if smaller. To check the audio, start playback of the connected device.
This function is not effective in Zone 2/Zone 3.
2. Name Edit
Set an easy name to each input. The set name will be shown on the main unit
display. Select the input selector to configure.
Name Edit
Default Value: Input name
1. Select a character or symbol with the cursors and press ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower cases. (Pressing MODE on the
remote controller also toggles between upper and lower cases)
"←" "→": Moves the cursor to the arrow direction.
" ": Removes a character on the left of the cursor.
" ": Enters a space.
Pressing CLR on the remote controller will remove all the input
characters.
