AM Noise Cut Mode
Default Value: 1
You can improve reception sensitivity by changing this mode if you are
finding AM broadcasts difficult to hear. Select "1" or "2".
2. Remote ID
Remote ID
Default Value: 1
Select an ID for the unit's remote controller from "1", "2", and "3" to prevent
interference between the unit and other ONKYO components that are
installed in the same room. After changing the ID on the main unit, change
the ID on the remote controller accordingly with the following procedure.
While holding down MODE, press the following numeric buttons for about 3
seconds.
To change the remote controller ID to "1": 1
(MAIN button flashes once.)
To change the remote controller ID to "2": 2
(MAIN button flashes twice.)
To change the remote controller ID to "3": 3
(MAIN button flashes three times.)
3. Preamp Mode
If speakers are connected to the PRE OUT jacks on this unit via a power amplifier,
you can reduce the power consumed by this unit by turning off the power supplied
to the SPEAKERS terminals you are not using on this unit.
Preamp Mode
Default Value: No
Select the SPEAKERS terminals whose power you want to turn off.
"No": Power is supplied to all SPEAKERS terminals. Select when a power
amplifier is not connected.
"Front": Turns off the power for the SPEAKERS terminals for the front
speakers.
"Front + Center": Turns off the power for the SPEAKERS terminals for the
front speakers and center speaker.
"All": Turns off the power for all SPEAKERS terminals. Select when this unit
is to be used as the preamplifier.
This setting cannot be selected when biamp connection is used for
speakers.
4. Firmware Update
Update Notice
Default Value: Enable
