4-6
Section 4
CONNECTING TO EXTERNAL DEVICES
ZUV
User’s Manual
Section 4
Connection by an I/O Terminal Block
Timing Charts
The following shows the timing charts when communication is performed with external
devices.
■
Ready output/display
Ready output turns ON when the controller is ready for irradiation.
• The response time is within 200 ms of the change in state of the ready output signal.
• The ready output of all channels turns ON after irradiation of all channels on the
irradiation target (other than OFF) ends.
• The ready output signal is always OFF for channels whose irradiation setting is OFF.
• The response time is within 200 ms of the change in state of the ready output signal.
• The ready output of the target channel turns ON after the irradiation of the target
channel ends.
• The ready output signal is always OFF for channels whose irradiation setting is OFF.
CH1 irradiation
CH1 READY
CH2 irradiation
CH2 READY
200 ms
<Batch Control>
CH1 irradiation
CH1 READY
CH2 irradiation
CH2 READY
200 ms
200 ms
<Individual Control>
Summary of Contents for ZUV Series
