2-2
Sec
tion 2
ZUV BASIC
OPERA
T
ION
ZUV
User’s Manual
Section 2
Starting Up and Shutting Down
Starting Up and Shutting Down
• Before turning ON the power supply confirm that the controller and head are properly connected.
• Remove the key from the key switch when the controller is not in operation.
■
Starting Up
1.
Check that the key switch on the controller front is set to the LOCK position.
2.
Set the power switch on the controller rear to
ON.
• The ON/OFF direction differs between the AC
power supply and the DC power supply.
• The Japanese-to-English selection message is
displayed only at initial startup.
• When the password function is enabled, the
password must be entered.
3.
Insert the key in the key switch on the
controller front and turn it to the [READY]
position when the LOCK mode top menu is
displayed.
The ZUV enters the irradiation ready mode.
In addition, the UV READY indicator on the head, which
is in the irradiation ready mode, lights up when the
mode is switched to the READY mode.
Never look directly at or allow your skin to be exposed to the
ultraviolet light.
To prevent exposure to ultraviolet light, never look into the ultraviolet
light.
Workers should wear protective goggles and equipment to protect them from being
exposed to reflected light.
Electric shock or light leakage may cause injury.
Do not disassemble the product.
Power supply
switch
Summary of Contents for ZUV Series
