3
Introduction
The Servo System 1S-Series Startup Guide
(hereinafter, may be referred to as "this Guide")
describes the procedures for installation and setup of a
1S Servo Drive, where an
NJ/NX-series CPU Unit is used in combination with1S-series AC Servomotors/Servo Drives and
NX-series Safety Unit, by using the Sysmac Studio. A simple installation model is used for the
discussion. You can perform the procedures that are presented in this Guide to quickly gain a
basic understanding of a 1S-series AC Servomotors/Servo Drives.
This Guide does not contain safety information and other details that are required for actual use.
Thoroughly read and understand the manuals for all of the devices that are used in this Guide to
ensure that the system is used safely. Review the entire contents of these materials, including
all safety precautions, precautions for safe use, and precautions for correct use.
Intended Audience
This Guide is intended for the following personnel.
•
Personnel in charge of introducing FA systems
•
Personnel in charge of designing FA systems
The personnel must also have the following knowledge.
•
Knowledge of electrical systems (an electrical engineer or the equivalent)
•
Knowledge of NJ/NX-series CPU Units
•
Knowledge of NX-series Safety Units
•
Knowledge of Servomotors/Drives
•
Knowledge of operation procedure of Sysmac Studio
Applicable Products
This Guide covers the following products.
•
CPU Units of NJ/NX-series Machine Automation Controllers
•
Automation Software Sysmac Studio
•
1S-series Servomotors/Servo Drives
•
NX-series EtherCAT Coupler unit
•
NX-series Safety controller
Special Information
The icons that are used in this Guide are described below.
Additional Information
Additional information to read as required.
This information is provided to increase understanding or make operation easier.
Precautions for Correct Use
Precautions on what to do and what not to do to ensure proper operation and
performance.
Summary of Contents for R88D-1SNx-ECT Series
Page 17: ...17 2 Approach the drive from top to down 3 Tight the upper part 4 Tight the down part...
Page 38: ...38 6 Add the Emergency stop button 7 Add the Reset button 8 Edit I O Map variables...
Page 58: ...58 11 Results Wizard step 5 Save to EEPROM Finish...
Page 59: ...2016 0616 0616 I823 E1 01 Note Do not use this document to operate the Unit...