43
■ Setting the axis
This section describes how to add the axis that is used to control the Servo Drive, assign it to the Servo
Drive, and set the axis parameters.
1.
Right-click MC_Axis000 (axis 0) in the Multiview Explorer and select Edit from the
menu.
Axis 0 is added to the Multiview Explorer. The axis is added as MC_Axis000.
2.
Right-click MC_Axis000 (axis 0) in the Multiview Explorer and select Edit from the
menu.
The Axis Basic Settings are displayed on the Axis Parameter Settings Tab Page in the Edit
Pane.
Summary of Contents for R88D-1SNx-ECT Series
Page 17: ...17 2 Approach the drive from top to down 3 Tight the upper part 4 Tight the down part...
Page 38: ...38 6 Add the Emergency stop button 7 Add the Reset button 8 Edit I O Map variables...
Page 58: ...58 11 Results Wizard step 5 Save to EEPROM Finish...
Page 59: ...2016 0616 0616 I823 E1 01 Note Do not use this document to operate the Unit...
