xi
About this Manual:
This manual describes the installation and operation of the SYSMAC CS1-series CS1W-ETN01 Ethernet
System and includes the sections described on the next page.
An Ethernet Unit is classified and treated as a CPU Bus Unit in PC processing.
This manual is based on Ethernet* networks comprised of Ethernet Unit nodes and UNIX* host computer
nodes. Although details can vary, theoretically any device supporting the same Ethernet protocols as the
Ethernet Unit can form nodes on the network.
Note *Ethernet is a trademark of the Xerox Corporation. UNIX is a registered trademark of USL.
Please read this manual and all related manuals listed in the following table carefully and be sure you
understand the information provided before attempting to install and operate an Ethernet Unit.
Name
Cat. No.
Contents
SYSMAC CS1-series
CS1W-ETN01 Ethernet Unit
Operation Manual
W343-E1-1
Describes the installation and operation of CS1W-ETN01
Ethernet Unit.
Refer to the CX-Programmer User’s Manual for information on
setting the CPU Bus Unit Setup for the Ethernet Unit.
Refer to the CS1G/H-CPU
jj
-E Programmable Controllers
Communications Commands Reference Manual (W342) for
information on FINS commands that can be addressed to
CS1-series CPU Units. (This manual)
SYSMAC CS1-series
CS1G/H-CPU
jj
-E
Programmable Controllers
Operation Manual
W339-E1-1
Describes the installation and operation of the CS1-series PCs.
SYSMAC CS1-series
CS1G/H-CPU
jj
-E
Programmable Controllers
Programming Manual
W340-E1-1
Describes the ladder diagram programming instructions
supported by CS1-series PCs.
SYSMAC CS1-series
C200H-PRO27-E, CQM1-PRO01-E
Programming Consoles
Operation Manual
W341-E-1
Provides information on how to program and operate
CS1-series PCs using a Programming Console.
SYSMAC CS1-series
CS1G/H-CPU
jj
-E,
CS1W-SCB21/41, CS1W-SCU21
Communications Commands
Reference Manual
W342-E1-1
Describes the C-series (Host Link) and FINS communications
commands used with CS1-series PCs.
SYSMAC WS02-CXP
jj
-E
CX-Programmer Operation Manual
---
Provides information on how to use the CX-Programmer, a
programming device that supports the CS1-series PCs.
SYSMAC CS1-series
CS1W-SCB21/41, CS1W-SCU21
Serial Communications Boards and
Serial Communications Unit
Operation Manual
W336-E1-1
Describes the use of Serial Communications Unit and Boards
to perform serial communications with external devices,
including the usage of standard system protocols for OMRON
products.
SYSMAC WS02-PSTC1-E
CX-Protocol Operation Manual
W344-E1-1
Describes the use of the CX-Protocol to create protocol
macros as communications sequences to communicate with
external devices.
WARNING
Failure to read and understand the information provided in this manual may result in
personal injury or death, damage to the product, or product failure. Please read each
section in its entirety and be sure you understand the information provided in the section
and related sections before attempting any of the procedures or operations given.
!
