Omron CS1W-CT021, Operation Manual

Page: 35 / 201

;4#"%'(*2-!")$#.&"#-:&(.#<(*#+
Section 1-5
%-
1-5 Operating Procedure Guidelines
The DIP switch at the back of the Unit can be used to operate every Counter as
Simple Counter or as Circular/Linear Counter. Setting the DIP switch in the appro-
priate position defines the Counter Type.
The Operation Procedure Guidelines consists of 5 steps. In step 1 of the
Operating Procedure Guidelines for every Counter the Type has to be set with
the DIP switch into one of the following configurations:
Next you must execute step 2, 3, 4, and 5. Once the I/O table is created in step 5,
the Unit must be configured if you have chosen for Configuration 2 or 3. If you have
chosen for Configuration 1 the Unit is ready to operate. Consequently guidelines
to be followed after step 5 will depend on the Configuration made in step 1.
Setting Counter Type
1, 2, 3… 1. Set the Counter Type for every Counter at the back of the Unit. Refer to 2-1-3
"Counter Type Switch" for further details.
2. Set the Machine Number. Refer to 2-1-4 "Machine Number Switch" for further
details.
Configuration 1 All Counters as Simple Counter
Configuration 2 All Counters as Circular/Linear Counter
Configuration 3 Mixed configuration of Simple/Circular/Linear Counters
Counter Type Switch:
OFF = Simple Counter
ON = Circular/Linear Counter
Machine Number Switch:
Set between 00 - 92
MACH
No.
W902-E2-03.book Seite 20 Donnerstag, 7. Oktober 2004 2:06 14