Omron CS1W-CT021, Operation Manual

Page: 128 / 201

H#>)"D-=<<)$%'()*
Section 4-2
$$&
Word Bit Item Function
m+138, m+139 00-15 Rate-Range 1
Lower Limit Rate-Range 1 Lower Limit
m+140, m+141 00-15 Rate-Range 1
Upper Limit Rate-Range 1 Upper Limit
m+142, m+143 00-15 Set Pattern
Rate-Range 1 Output Set Pattern Rate-Range 1
m+144, m+145 00-15 Reset Pattern
Rate-Range 1 Output Reset Pattern Rate-Range 1
m+146 00 Rate-Range 0 Enable Enable (=1) / Disable (=0) Rate-Range 0
01 Rate-Range 1 Enable Enable (=1) / Disable (=0) Rate-Range 1
02-15 --- Not used
m+147, m+148 00-15 Range / Comparison
Enable Data Enable Ranges / Comparison Values (1=Enabled,
0=Disabled) (depending on Unit in Range /
Comparison Mode).
Bits set for non-existing ranges or CV’s will be ignored
m+149, m+150 00-15 Output Set Pattern Output [0-31] Set Pattern for Comparison Mode
1= set, 0 = no change
m+151, m+152 00-15 Output Reset Pattern Output [0-31] Reset Pattern for Comparison Mode
1= reset, 0 = no change
m+153 00-15 Hysteresis Define required Hysteresis (0000
≤
Hysteresis
≤
00FF
counts). Hysteresis (=0) means Hysteresis is OFF.
m+154 00-07 # Ranges /
Comparison Values Set number of Ranges/ Comparison Values
[0, 32
(BCD)
]
08-15 --- Not used
m+155 00-03 Memory Area Memory Area where Range / Comparison Data is stored:
0 = EM (=default)
1 = DM
04-15 --- Not used
m+156, m+157 00-15 Memory Address Beginning Address (in EM/DM) where first Range /
Comparison Data is stored [00000, 32760
(BCD)
]
m+158 to m+164 00-15 --- Not used
W902-E2-03.book Seite 113 Donnerstag, 7. Oktober 2004 2:06 14