CHAPTER 10 |
50
AM MENU
Multiband AGC Menu
The
Multiband AGC
menu hosts the controls for setting maximum gain, ratio, progressive release, AGC levels, and
AGC speed.
♦
The
Maximum Gain, Ratio,
and
Progressive Release
controls work in the same manner as their counter-
parts in the other sections of the Omnia.7 as explained earlier in this manual.
♦
The
MB AGC Levels
menu has a sub-menu of its own with the following controls:
¸
The
AGC Target (coupled), Band Mix (coupled),
and
Drive (coupled)
controls work in the same
manner as their counterparts in the other sections of the Omnia.7 as explained earlier in this manual.
¸
The AGC Target
controls set the target output level of each band of the Multiband AGC. A lower
setting provides a lower output level, while a higher setting provides a higher output level. These are
duplicates of the AGC Target controls located in the
Multiband Thresholds
menu.
¸
The
Band Mix
controls allow you to adjust the final output of each band after all Wideband and
Multiband processing has been applied and are duplicates of those found in the separate
Band Mix
menu. Please see the section on the
Band Mix
menu below which contains additional important
information about these controls.
¸
When raising the target of a particular band (to increase gain and consequently raise its output) it
was normally necessary to reduce the output of the same band in the band mix control to compensate.
Likewise, lowering the target of a band (to decrease gain and therefore lower its output) it was
necessary to increase the output of that band in the band mix menu.
¸
The
Drive
controls provide simultaneous and opposite adjustment to both the
AGC Target
and
Band
Mix
controls. This allows the overall spectral balance to remain consistent.