Omni Group Viverra, Manual

Page: 8 / 40

THE IDENTIFICATION PLATE MUST NEVER BE REMOVED.
1.10 GENERAL SAFETY INFORMATION
During project and manufacturing phases, the Builder paid careful attention to all those situations
that might cause risks to the safety and the health of people. The relevant laws were fully
respected and all the “rules of good building technique” were applied. The aim of this type of
information is to raise the awareness of users on the importance of preventing any risk, always
using caution.
Carefully read the information reported in the manual and placed directly on the machine,
especially safety information.
Please read this manual carefully before using or servicing the machine.

Do not tamper with, sidestep, eliminate or bypass the safety and warning devices
installed on the machine. Non-compliance with this requirement can cause serious risks
and can compromise the safety of people.

Never start the machine with the fixed or mobile guards disassembled.

Never inhibit the emergency features installed on the machine.

The regulating operations, with reduced safety, must be done by a qualified technician
and during their progress it is necessary to prevent access to the machine by
unauthorized persons.

After adjusting the machine under reduced safety conditions, restore proper safety
conditions as soon as possible.

Make sure that the machine is connected to an efficient earthling circuit.

Do not modify, for any reason, any part of the machine in order to adapt other devices.
In case this condition is not respected, the Builder CANNOT be held responsible for
IGM EN_REV4 8