Omni Group Viverra, Manual

Page: 27 / 40

Dispose of packaging material in accordance with the laws in force in the Country of installation.
The removed packaging materials and all materials collected in the final cleaning phase (wood,
metal, plastic, any oily residues, cloths, brackets, cable materials, etc.) must be separately
collected according to their type and differently disposed of, in compliance with the environmental
protection laws in force.
Should it be necessary to close the machine in a box (e.g. for sea or air transport), the box must
have a perimeter base similar to the one of the machine, but 200 mm larger on all sides, with a
capacity adequate to the machine weight, and with the appropriate identification pictograms
stamped on (together with the indications “THIS SIDE UP” and “HANDLE WITH CARE”).
In the case above or in case of transport on self-propelled vehicles, the machine must be fixed to
the box base. The box’s feet must be as high as to allow the passing of lift trucks forks.
4.3 STOCKING
In case of a long period of inactivity store the machine:
-
in a closed place, protected from severe weather conditions and humidity;
- protecting it from collisions and other types of stress;
-
preventing it from coming into contact with corrosive substances.
While the machine is inactive, waiting to be started, it must be located in a dry place, protected
from the elements.
The elements that could be deteriorated by the weather must be isolated with protective nylon (as
in environment where the quantity of saltiness is high).
4.4 INSTALLATION
The machine can be installed by the Builder or directly by the Customer following these
instructions.
Remove the packaging material and place the machine on a solid and levelled surface that can
support its mass and the mass of the products that will be wound.
To ensure the correct functioning of the machine, the bearing surface must be flat and levelled.
By means of a correct installation the line is more rigid and vibrations and noises are reduced.
If the machine is shipped with the column reclined on the plastic cover, proceed as described
below to correctly install the machine:
IGM EN_REV4 27