background image

AIR LIFT

INSTRUCTIONS 

l  

PARTS DRAWING 

l  

PARTS LIST

WARNING: READ INSTRUCTIONS BEFORE OPERATING

1. Center load on table - 1000 lb. maximum.

2. Connect to 100 psi maximum shop air.
3. Keep safety bar in position at all times - except  

when lowering.

4. Keep hands and tools from under carriage.
5. Do not mount table when in elevated position.
6. Do not ride vehicle onto lift.
7. Lift must be in the lowered position when moving.
8. Only trained persons should operate Air Lift.
9. The working area should be sufficiently lit.

10. Foot controller should be at least 3 feet away from

Air Lift during raising and lowering operation.

11. Recommended for indoor use only.

HANDY INDUSTRIES DIVISION OF JADEIM, LLC 

401 South 2nd.    Marshalltown, IA 50158   

1-800-247-7594    Fax  641-752-1205   www.handyindustries.com

Part Numbers 10740 - 16749 -  16600

LIFT TABLE

DETENT BAR

FOOT VALVE

RAMP

SAFETY LATCH

Summary of Contents for Handy 10740

Page 1: ...6 Do not ride vehicle onto lift 7 Lift must be in the lowered position when moving 8 Only trained persons should operate Air Lift 9 The working area should be sufficiently lit 10 Foot controller should be at least 3 feet away from Air Lift during raising and lowering operation 11 Recommended for indoor use only HANDY INDUSTRIES DIVISION OF JADEIM LLC 401 South 2nd Marshalltown IA 50158 1 800 247 7...

Page 2: ... 6 months to prevent galling Grease zerks are located at each end of frame pivot shaft and at top ends of inside frame assembly 4 Lightly oil cylinder rod when it becomes dry 5 Squirt some oil through air bleed hole in plate end of cylinder to lubricate piston and its seal every 6 months 6 Pivot shaft set screws should be checked frequently to be sure they are tight These are located at the top en...

Page 3: ...1254 Frame Shaft Retaining Ring 2 14381 Valve Hose w fittings 1 11255 Lock washer 1 11123 Ramp Assembly Gray 1 11304 Cylinder Shaft Bushing 1 12937 Foot Valve Assembly complete 1 11305 Cylinder Shaft Seal 1 12887 Valve Stem Assembly 1 11306 Piston Seal 1 11177 Detent Bar 1 11308 Piston 1 11179 Frame Pivot Shaft 1 11315 Cam Roller Bearing 4 11183 Cylinder Repair Kit 1 11316 Cam Bearing Spacer 2 112...

Page 4: ...ip will be replaced or put in good operating condition This warranty does not apply to dam age resulting from accident improper installation repair operation or maintenance negligence or neglect THE COST OF SUCH REPLACEMENT OR REPAIR SHALL BE EXCLUSIVE REMEDY FOR ANY BREACH OF ANY WARRANTY AND HANDY INDUSTRIES SHALL NOT BE LIABLE TO ANY PERSON FOR CONSEQUENTIAL DAMAGE OR INJURY OR COMMERCIAL LOSS ...

Reviews: