Page: 110
Step 3
Κ
Κ
Set the type code to the type you want to calibrate.
Select the AI range (e.g. 09, -
5V ~ 5V) then click “Submit” button.
Step 4
Κ
Enable calibration.
We will use the software
–
Modbus Master Tool - to complete the step 4 ~ 8.
The complete version of the Modbus Master Tool can be obtained from the
companion CD:
CD:\Software\Modbus_Master_Tool\
4.1 Please double-
click the “ModbusMasterToolPC.exe” to open it
and
c
lick the “Setup > Definition” in menu bar to setup the parameters.
3.
2.
It depends on the settings in Modules I/O Settings -
Modbus Definition (refer to Section 3.2.3)
Select
“
01 Read Coils Status
”
(no
matter what kind of module you use).
Rrefer to the table below - Modbus
Address for Calibration. (830 ~ 832)
1.
2.
3.
Summary of Contents for OME-ET-7000 Series
