7-7
Sample Program
7
7.3
RS-422-A/RS-485 Sample Programs
This section describes sample program for a system using PC9801 series (NEC) with the RS-422-A/
RS-485 interface. We hope that these samples will aid you in creating your own program.
Configuration
Model
: NEC PC9801 series
Language
: N88-BASIC (Standard programming language on the PC9801 series)
Wiring system
: four-wire system (both four-wire and two-wire systems are introduced in this
manual for the ASCII output of the measured data).
Setting the RS-422-A/RS-485 Parameter
Baud rate
: 9600
Data length
: 8
Parity
: Even
Stop bit
: 1
Address
: 01
Setting the Personal Computer
Be careful when receiving BINARY data that the received data does not overrun the capacity of the
receive buffer in the personal computer which may be small as 255 bytes in some case.
Output the Setting Data
Read out the setting data from DR series, display them on CRT of the personal computer, and save
them to floppy disk.
10
‘
20
OPEN “COM1:E81N” AS #1
30
OPEN “TS1.DAT” FOR OUTPUT AS #2
40
‘
50
PRINT #1,CHR$(&H1B)+”O 01"
60
LINE INPUT #1,D$ :PRINT D$
70
PRINT #1,”TS1"
80
LINE INPUT #1,D$ :PRINT D$
90
PRINT #1,CHR$(&H1B)+”T”
100
LINE INPUT #1,D$ :PRINT D$
110
PRINT #1,”LF001,010"
120
LINE INPUT #1,D$
130
PRINT D$
140
PRINT #2,D$
150
IF LEFT$(D$,2)<>”EN” THEN GOTO 270
160
‘
170
PRINT #1,CHR$(&H1B)+”C 01"
180
LINE INPUT #1,D$ :PRINT D$
190
CLOSE
200
END
Summary of Contents for DR130 SERIES
Page 39: ...4 9 Command Format 4 4 5 Input Range Parameter This page intentionally left blank ...
Page 40: ...4 10 4 5 Input Range Parameter This page intentionally left blank ...
Page 56: ...5 15 Commands 5 This page intentionally left blank 5 5 Other Settings ...
Page 71: ...6 9 Output Format 6 This page intentionally left blank ...