Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 22
55.
Starting on the short roof side, locate 3
Long Metal Roof Panels (39” wide x 43” long)
and
3 Metal
Roof Hangars
. To temporarily hold the Metal Roof Panels in place, hook a Metal Roof Hangar onto lowest
Batten approximately where the center of the first panel will be. Place the first Metal Roof Panel on Battens
and into Hangar. Do no fasten Panels down until
Step 60
. Place remaining 2 panels and Hangars on the
same way. Metal Roof panels will overlap each other.
Important:
Do not fasten down Roof Panels with Hangars still in place. Metal Roof
Hangars will temporarily help keep Metal Roof Panels in place before they are fastened.
56.
Overhang the
Metal Roof Panels
past the Battens on sides by approximately 1”. Adjust panels side
to side to achieve desired width. Overall width past the Battens can vary from 1” - 3” depending on your
preference. The overhang over the side of the shed will be set by the
Metal Roof Hangars
, but should be
approximately 4” on the side of shed.
Approximately 4” of overhang.
