Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 15
35.
Attach end of a 45 1/2” long Soffit Board flush to ends of outside rafter with 2 - 1 1/4” screws per rafter
end. Drill pilot hole in Soffit to prevent splitting. Attach Ridge Board to opposite rafter end, aligning to
bottom of rafter, with 2 - 1 1/4” screws. Center Soffit on Middle Rafter and secure with
2 - 1 1/4” screws. Measure 45 1/2” from outside rafter and secure Ridge Board to rafter with 2 - 1 1/4” screws.
Important:
Ridge Board
must be aligned to bottom of
rafter end in this position.
C. Rafter Section
34.
Starting with
LONG ROOF SIDE
, locate 2
Ridge Boards
(3/4” x 4 5/8” x 33 1/2” and
3/4” x 4 5/8” x 57 1/2”). Attach together with
Metal Ridge Board Connector
using 8 - 3/4” screws.
Locate 6 - 1 1/2” x 3 1/2” x 77 3/4”
Rafters
and 2 - 1/2” x
4 1/2”
x 45 1/2”
Soffits
and lay out on a
flat level surface as pictured. Screw doubled up rafters together with 3 - 2 1/2” screws.
Note: Soffits
for long roof side are 4 1/2” wide, short roof side are 3 1/2”.
4 5/8” Ridge Board
Metal Ridge Board
Connector
Centered on
Rafter
Sof
fit
Long Roof Side
36.
Measure, position and attach all Rafters as illustrated above.
Important:
Measure
20 1/2” spacing accurately
to accomodate Polygal
Panels in
Step 56.
Important:
Pilot Hole
Ridge Board and Soffit
to prevent splitting!
77 3/4” Rafters
Ridge Board
Sof
fit
4 1/2” wide Sof
fits
Ridge Boards
Double up Rafters
91”
23 1/2”
20 1/2”
45 1/2”
45 1/2”
20 1/2”
