Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 16
37.
Complete
Short Roof
Side Rafter Section
as per
Steps 34 - 36
with the following
exceptions:
Rafters length =
37 3/4” long
Soffit width =
3 1/2” wide
Ridge Board =
5 1/8” wide
38.
Starting with the Short Roof Side, lift and flip completed Rafter section over with Soffit now
facing down. Slide rafter up on gable framing until bottom of Ridge Board slips into gable notch.
Position rafters so they sit evenly on Gable framing from side to side.
Slide Bottom of Ridge
Board into notch of gable.
40.
Lift and flip Long Rafter Side up and
place on Gable framing
. Make sure Metal
Ridge Board Connectors of both Roof
Sections are offset. See Diagram Step 41.
Important:
make sure Metal
Ridge Board Connectors on
Long Roof side and Short
Roof side are offset.
See
Diagram Step 41.
gable notch
39.
Where Wall and Soffit meet, a
small gap may appear. Confirm all
Rafters are resting on Top Plate.
Soffit should sit
approx. 1/8” away
from wall panel.
3 - 2 1/2” screws.
37 3/4” Rafters
3 1/2” wide Sof
fit
5 1/8” Ridge Board
Short Roof Side
