Olicom CrossFire 8730, Reference Manual

Page: 133 / 234

119
CrossFire 8730 Switch Reference Guide, DOC-7047 v. 1.1 Switch Configuration
this parameter is 9600. Make sure that your terminal emulator baud rate matches
the console baud rate you set.
Creating a Console Session Using a Modem
Use the Serial Link Configuration menu to configure the switch in order to
communicate with a console via a modem.
Set your modem according to the table below.
➽
Caution: Some modems use slightly different names for the options. It is important
that your modem be configured correctly. The settings shown in italics are
particularly important. If your modem is not configured correctly, the connection
may cause the switch to reset.
Start the console by pressing
ENTER
. If a Telnet session is active, press
ENTER
at
the console to terminate the Telnet session and press
ENTER
again to start the
console session.
Stopping the Console Session
Pressing
CTRL-P
returns the console session to the main menu, and pressing
CTRL-
B
returns to the greeting menu.
Setting Value
Echo Off
Result codes Off
Wait for connection 45 seconds
Pause between calls 6 seconds
Drop DTR between calls Yes
Send CR between calls Yes
Auto baud detect On
Send init if CD high Yes
Maximum dial attempts 999
Table 12. Modem Settings