Second Paper Feeder
E - 15
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602
• ( JAM error )
Paper Input Jam
• Does paper jam at input when the power is turned on?
• YES
Is the paper located above the sensor plate (Inlet)?
• YES
Remove the paper.
▼
• NO
Is the sensor plate (Inlet) operating normally?
• NO
Replace the sensor plate (Inlet).
▼
• YES
Replace the power supply board or inlet sensor.
▼
• NO
When the paper is fed in, does the paper input jam occur?
• YES
Is the paper being fed to above sensor plate (Inlet)?
• YES
Is the sensor plate (Inlet) operating normally?
• NO
Replace the sensor plate. (Inlet)
▼
• YES
Clean the inlet sensor on the power supply board or replace
the power supply board or inlet sensor.
▼
• NO
Replace the hopping roller shaft assy or paper cassette.
▼
• NO
Is the hopping roller shaft rotating?
• YES
Set the paper properly.
▼
• NO
Is the stepping motor turning?
• YES
Replace the one-way clutch gear on the hopping roller shaft assem-
bly.
▼
• NO
Is the connector cable connected properly?
• NO
Connect the connector cable properly.
▼
• YES Check the coil resistance (approx. 32
Ω
) of the pulse motor.
Is is normal?
• NO
Replace the pulse motor.
▼
• YES Replace the OLEV-12 PCB.