OKIDATA 610e, Service Manual

Page: 196 / 222

Multi-Purpose Feeder D - 17 OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602
JAM Error
Paper Input Jam
• Does paper jam at the inlet when the power is turned on?
• YES Is the paper located above the sensor plate (Inlet)?
• YES Remove the paper.
▼
• NO Is the sensor plate (Inlet) operating normally?
• NO Replace the sensor plate (Inlet).
▼
• YES Replace the power supply board or inlet sensor.
▼
• NO When the paper is fed in, does the paper input jam occur?
• YES Is the paper being fed to above sensor plate (Inlet)?
• YES Is the sensor plate (Inlet) operating normally?
• NO Replace the sensor plate (Inlet).
▼
• YES Clean the Inlet sensor on the power supply board or replace
the power supply board or Inlet sensor.
▼
• NO Replace the roller-A or roller-B.
▼
• NO Are roller-A and roller-B rotating?
• YES Set the paper properly.
▼
• NO Is the pulse motor turning?
• YES Replace planet gear.
▼
• NO Is the connector cord connected properly?
• NO Connect the connector cord properly.
▼
• YES Check the coil resistance (approx. 32
Ω
) of the pulse motor.
Is is normal?
• NO Replace the pulse motor.
▼
• YES Replace the OLEV-11 PCB.