Troubleshooting
6 - 36
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602
8
White Vertical Belts or Streaks
• Is the LED lens dirty?
• Yes
Clean the LED lens.
▼
• No
Is the contact plate of the transfer roller in proper contact with the power supply
board (see Fig. 6-5)?
• No
Adjust the contact plate to make a proper contact with the power supply
board.
▼
• Yes
Replace the transfer roller.
• Has the problem been eliminated?
• Yes
End
▼
• No
Is the LED head installed properly (check CN4 connector on the Main Control PCB
and PC connector on the LED head)?
• No
Install the LED head properly.
▼
• Yes
Replace the LED head.
• Has the problem been eliminated?
• Yes
End
Note:
Set the LED head drive time if the luminous rating of the old head and
the new head are different.
OL610e/PS: See 4.2. OL600e/610e: See
Software Supplement.
▼
• No
Replace the image drum cartridge. Reset the drum counter from the User
Maintenance mode (OL610e/PS), or from the Service menu of the Status Monitor
(OL600e/610e).
• Has the problem been eliminated?
• Yes
End
Note:
After replacing the image drum cartridge, set the printer in the user
maintenance mode by turning the power on while pressing the MENU
key. Reset the drum counter (see User’s Manual).
▼
• No
Replace the Main Control PCB or power supply board.
