Oki ES9455, Software Setup Manual

Page: 180 / 386

8 [Administration] Tab Page
178 [Setup] Item List
7 Destination Address Specify the destination address for the communication to which the filter is applied.
y Specific IP Address — Set a specific IP address. Enter the IP address in the address
input box.
y Subnet / Prefix — Set the destination with its IP address and subnet mask. Enter the IP
address and the prefix of the subnet mask directly in the address input box.
y FQDN — Sets FQDN for the destination. Enter FQDN in the address input box. You can
enter up to 255 alphanumerical characters including hyphen (-) and period (.). However,
neither hyphen (-) nor period (.) can be used as first or last character.
y Any IP Address — Set any IP address.
8 Protocol Type Select a protocol for the filter.
y Any — Set any protocol.
y TCP — Select this to use TCP only.
y UDP — Select this to use UDP only.
y ICMP — Select this to use ICMP only.
9 Source Port Specify the source port number. This setting is available only if you selected TCP or UDP in
the protocol type setting.
y Any — Set any source port.
y Port Number — Set the port number of the sender. Enter the port number in the port
number input box.
10 Destination Port Set the destination port number. This setting is available only if you selected TCP or UDP in
the protocol type setting.
y Any — Set any destination port.
y Port Number — Set the port number of the destination. Enter the port number in the
port number input box.
11 Filter Action Set the operation of the filter.
y Permit — Select this to permit access from the specified destination.
y
Block — Select this to block access from the specified destination.
y Negotiate Security — IPsec communication is performed with the specified
destination. When this item is set, you must select the security protocol type to be used
in IPsec communication from the following:
- ESP — Select this to use ESP (Encapsulating Security Payload).
- AH — Select this to use AH (Authentication Header).
Item name Description