10
Defender 5000 Indicators Service Manual
1.7.3 RS232 Interface Cable to TD52XW
Pass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal block
J5 (Figure 1-3, item 7). Tighten the strain relief to maintain a watertight seal.
1.7.4 MICRO SD Card Installation
The SD memory card can be used for additional storage in the Checkweighing and Counting applications.
Figure 1-8 shows the installation of an SD card into the socket on the edge of the TD52P andTD52XW main
board.
Figure 1-8 Sliding an SD Card into the SD Socket (left); SD Card Installed (right)
1.8 TD52XW Rear Housing Orientation
The TD52XW is delivered in the wall mount orientation with the connections exiting below the display. The
rear housing may be reversed so the connections exit above the display when the TD52XW is placed
horizontally on a bench. To reverse the rear housing, remove the four Phillips head screws, carefully rotate
the housing 180°, and reinstall the screws.
Figure 1-9 Wall Mount Configuration
Figure 1-10 Bench Top Configuration
1.9 Mounting Bracket
Attach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type of
mounting surface. The bracket will accommodate up to 6 mm (1/4”) diameter screws. Locate the mounting
holes as shown in Figure 1-11.
