Officine Gullo ELG 90, Instructions For Installation And Use Manual

Page: 58 / 66

14
Adjustments
- Burners on the hob
- Bruciatore del forno
When installing the cooker, you must check that the minimum gas flow of the burners on
the hob and in the oven is correctly regulated.
If the type of gas is changed it is indispensable to adjust the minimum flow. The regula -
ting procedure is as follows.
1. Light one burner at a time and turn the flame
up tomaximum.
2. Remove the knob of the corresponding gas
tap andinsert a screwdriver in the end part of
the tap or in thescrew (fig. A1,A2).
3. Turn the tap to minimum position.
4. Unscrew, turning to the left, to increase the
flame, orscrew to the right to decrease it.
5. If a liquid gas is used (Butane - Propane),
theregulating screw must be fully screwed in.
1. Remove the bottom shelf of the oven.
2. Light the burner and leave it at maximum
for about 10minutes with the oven door closed.
3. Turn the knob to minimum and, still with the
doorclosed, check whether the flames have
lowered but arestill burning steadily
(about 3-4 mm).
4. Remove the knob of the thermostat.
Insert ascrewdriver on the proper screw (fig. B):
turn anticlockwiseto increase the minimum,
clockwise to decrease it. Theflame must be
steady and homogeneous.
5. If the flames are not well adjusted at minimum
level,repeat the procedure described above.
6. If a liquid gas is used (Butane - Propane),
the regulatingscrew must be fully screwed in.
ADJUSTMENTS
- Adjustments minimun GAS flow
Fig. C2
Officine Gullo 12