Officine Gullo ELG 90, Instructions For Installation And Use Manual

Page: 53 / 66

6
- The appliance can be installed singularly: class 1.
- The appliance can be installed between two pieces of furniture: class 2/1.
- The cooker is protected against excessive overheating, so it may be installed next to
furniture with a height no higher than that of the worktop. The wall in contact with the
back of the cooker must be made of fire-resistant material. To install the cooker correct -
ly, take the following precautions.
A. Any furniture in the vicinity of the cooker with a height higher than that of the worktop
must be at least 50mmfrom the edge of the top;
B. The extractor hood must be installed in the way indicated in its instructions booklet,
and always at a minimumdistance of 650 mm from the top of the hob;
C. If the cooker is installed under a wall unit, the minimum distance between this unit
and the worktop must be700 mm (millimeters).
INSTALLATION
- Installation of the cooker
Positioning of the ap-
pliance between furni-
ture
Min.
50 mm
Min. 650 mm
Min. 700 mm
7
Model: 60, 70, 80, 90 cm.
ATTENTION
- Unpack the cooker and mount the feet by adjusting the height.
- Measure the height from the floor to the top edge of the back-cross bar (picture 5) and
add 15mm.
- Sign the total height on the supporting back wall at the centre of the cooker width.
Make a holeby means of a 6 diam. point and install the fixing bracket (picture 6).
- Check that the cooker is leaning against the back wall to avoid tipping.
The anti-turnover system is assured only if the cooker is installed with the back
part leaned against the back wall.
INSTALLATION
- How to install the fixing bracket
7
Officine Gullo