177
Pompa di calore ad inverter per piscine
IT
Schema di montaggio del kit di by-pass per una pompa di calore
Schema di montaggio del kit di by-pass per più pompe di calore
Il fi ltro a monte della pompa di calore deve essere pulito regolarmente affi
nché
l’acqua di circolazione sia pulita e per prevenire eventuali problemi di funzionamento
causati da sporcizie o dall'intasamento del fi ltro.
Collegamento idraulico
3.6
13
By-Pass assembly for one heat pump
By-Pass assembly for more than one heat pump
The filter located upstream of the heat pump must be regularly cleared so that the water in the system is
clean, thus avoiding the operational problems associated with dirt or clog- ging in the filter.
Uscita
Impianto di
condizionamento
chimico automa-
tizzato dell'acqua
pompa
VERSO LA PISCINA
DALLA PISCINA
Piscina
Ingresso
13
By-Pass assembly for one heat pump
By-Pass assembly for more than one heat pump
The filter located upstream of the heat pump must be regularly cleared so that the water in the system is
clean, thus avoiding the operational problems associated with dirt or clog- ging in the filter.
Uscita
Uscita
pompa
VERSO LA PISCINA
DALLA PISCINA
Piscina
Ingresso
Ingresso
Impianto di
condizionamento
chimico automa-
tizzato dell'acqua
11
3.3 Installation layout
3.4 Connecting the condensation draining kit
While operating, the heat pump is subject to condensation. This will result in a more or less large run-off of
water, depending on the degree of humidity. To channel this flow, we recommend that you install the
condensation drainage kit.
How do you install the condensation drainage kit|?
Install the heat pump, raising it at least 10 cm with solid water-resistant pads, then connect the drainage pipe to
the opening located under the pump.
3.5 Installing the unit on noise-damping supports
In order to minimize the noise pollution associated with heat pump vibrations, it can be positioned on vibration
absorbing pads.
To do this, you simply have to position a pad between each of the unit’s feet and its support, and then fix
the heat pump to the support with suitable screws.
Valvola
completamente aperta
Valvola
semichiusa
11
3.3 Installation layout
3.4 Connecting the condensation draining kit
While operating, the heat pump is subject to condensation. This will result in a more or less large run-off of
water, depending on the degree of humidity. To channel this flow, we recommend that you install the
condensation drainage kit.
How do you install the condensation drainage kit|?
Install the heat pump, raising it at least 10 cm with solid water-resistant pads, then connect the drainage pipe to
the opening located under the pump.
3.5 Installing the unit on noise-damping supports
In order to minimize the noise pollution associated with heat pump vibrations, it can be positioned on vibration
absorbing pads.
To do this, you simply have to position a pad between each of the unit’s feet and its support, and then fix
the heat pump to the support with suitable screws.
