Oce XDL, Reference Manual

Page: 100 / 255

Summary of OUTPUT Command Parameters (Continuation) Print Processing
92
A29247-X4-X-8-7672
IMAGE=
(
img_name ,
vpos units ,
hpos units
[, n [/ d ]]
[, (INKS, inkref
[, inkref ]
[, ...])])
In the LCDS-Module this parameter is completely ig-
nored.
This command is unsupported as it applies only to
batch mode processing. The command is gracefully
processed by the XDL compiler and ignored. It is doc-
umented here for completeness only.
img_name
Specifies the name of the graphic image file.
vpos
Specifies the vertical position (top left corner of
page) of the top edge of the graphic, as an offset rel-
ative to 0,0 on the current physical page (the position
that would be specified by a PDE BEGIN of 0,0). This
parameter is specified as a decimal number with up
to three digits to the right of the decimal point.
hpos
Specifies the horizontal position of the left edge of the
graphic, as an offset relative to 0,0 on the current
physical page. The
units of the specification is the
same as for vpos . This parameter is specified as a
decimal number with up to three digits to the right of
the decimal point.
The default for
vpos and hpos is the top left corner
(default for n/d ) scaled 1/1.
units
DOTS (300 dots per inch), XDOTS (600 dots per
inch), centimeters (CM), user-defined units (UN) or
inches (IN). The default
units value is IN.
n/d
Specifies the reference scale factor. Each parameter,
n and d , must be an integer in the range of one to
eight, thereby allowing a reference scale factor in the
range of 1/8 to eight.
Scaling can result in performance problems, because
scaling is done page by page during printout.
inkref
Specifies which inks in the ILIST parameter of the
IDR command override the corresponding inks spec-
ified in the inklist of the image.
If one
inkref in the list is omitted, commas must be
used to maintain the relative positioning of the re-
maining ink references.
Y Y Y
Parameter Definition(s) Offline Online DJDE