Oce WP28, Operation Manual

Page: 92 / 227

Interface
1-76
Serial Interface Parameters
This section applies to the printers having the option serial interface
board kit (IB-11) installed.
The baud rate, data bits, stop bits, parity, and protocol for the serial
interface can be set as follows:
1
Press the
MENU
key.
2
Press the or key repeatedly until
Interface >
appears. One of
the interface names shown below appears, indicating the current
interface.
Parallel
(default)
USB
Serial
(when a serial interface board kit is installed)
Option
(when a network interface card is installed)
3
Press the
ENTER
key. A blinking question mark (
?
) appears.
If you want to abandon the interface selection procedure, press the
CANCEL
key. The interface remains unchanged.
4
Press the or key repeatedly until
Serial
appears.
5
Press the
ENTER
key again.
Option
Interface
? Parallel
Interface
? Serial