Oce WP28, Operation Manual

Page: 152 / 227

Print Quality Problems
4-4
Faint or blurred printing Check the Ecoprint setting.
When this setting is
On
, switch it to
Off
on the Operator
Panel. (See Ecoprint on page 1-54 )
Check the operator panel.
• If the
Toner low
message is displayed and the
ATTENTION
indicator is flashing, install a new toner
kit. See Toner Container Replacement on page
3-2 .
• Set the print density from the operator panel to a
higher level than the current setting. See
Print
Density on page 1-95 .
• Make sure the paper type setting is correct. See
Paper Type on page 2-12
Clean the charger wire.
Open the printer left cover. Pull the cleaning knob (green
colored) slowly in and out a few times. See
Cleaning on
page 3-9
Grey background. Check the operator panel.
If the
Toner low TK-50
message is displayed and the
ATTENTION
indicator is flashing, install a new toner kit.
See Toner Container Replacement on page 3-2 .
Check the print density.
Display the print density menu from the operator panel
and select a lighter density setting. See
Print Density on
page 1-95 .
Clean the charger wire.
Open the printer’s left cover. Pull the cleaning knob
(green colored) slowly in and out a few times. See
Toner
Container Replacement on page 3-2 .
Check the charger unit installation.
Open the printer left cover and check that the charger
unit is correctly installed and seated as far as it will go.
See
Cleaning on page 3-9 .
Printed Results Corrective Action
Table 4-2 (Continued)