Oce WP28, Operation Manual

Page: 144 / 227

Cleaning
3-9
Cleaning
To avoid print quality problems, the following printer parts must be
cleaned with every toner container replacement. In addition, the charger
wire and paper transfer unit should be cleaned from time to time, or
whenever print quality problems occur.
If the toner container was replaced when
Replace toner Clean
printer
was displayed,
Clean printer Press GO
will appear after
replacement. After cleaning the inside of the printer following the
procedure shown below, press the GO key; the message will disappear
and the printer will be ready for printing.
Cleaning the Charger Wire
The charger wire is a part in the drum unit that needs to be periodically
cleaned. You can clean the charger wire by pulling the cleaning knob as
instructed below.
1
Open the left cover on the left side of the printer.
2
Pull the cleaning knob (blue colored) slowly in and out a few times.
This cleans charger wire inside the printer.
Note
Left Cover Charger Unit
Cleaning Knob
(Blue)