Oce WP28, Operation Manual

Page: 95 / 227

Interface
1-79
6
Press the
>
key. Each time the or key is pressed, the display
changes as shown below.
7
The following example explains how to activate
TCP/IP
protocol to
connect the printer in the network. You can select
Netware
or
EtherTalk
in a similar manner.
If
TCP/IP
is currently
Off
is displayed, select
On
using the or
key. Press the
ENTER
key again.
>NetWare >
On
>TCP/IP >
On
>EtherTalk
Off
>Opt. StatusPage
On
Set this item to
On
when you connect to a
network using NetWare. In submenu (
>
),
frame mode can be selected from
Auto
,
Ethernet
,
802.2
,
802.3
, and
802.3 SNAP
.
Set this item to
On
when you connect to a
network using TCP/IP. Submenu (
>
) has
items including DHCP, IP address, subnet
mask address, and gateway address.
When the item is set to
On
, the printer prints
out a network status page when it prints the
printer status. See page
1-19
Range
EtherTalk must be activated (
On
) for
networking with Macintosh computers.
>TCP/IP >
On
>TCP/IP
? On >TCP/IP >
On