Oce VarioPrint 5000, Operating Manual

Page: 329 / 360

8.3.4 Predecurler
A29246-X17-X-4-7680 / do805.fm
319
8.3.4 Predecurler
Too much paper curling can impair the paper transport, e.g. in the area of the PC drum. You
can avoid these problems by checking and adjusting, if necessary, the Predecurler settings
before starting the print job,
see section 8.3.4.1 Setting the Predecurler, page 319 .
Then determine the paper curl value for the paper being used. For this, you will require the
curl measurement sheet as per ISO 14968. You will also find this in the paper specification
for single sheet printing systems (order no. A29249-X1-X7-59).
The Predecurler settings for the determined paper curl value can be found in the table under
8.3.4.2 Setting for Predecurler , page 321.
8.3.4.1 Setting the Predecurler
The paper required for the print job should be loaded into the input tray.
Note
• The upper and lower print units each have a Predecurler. You only need to set the
lower Predecurler because the upper one will automatically adjust to your settings.
• The setting is only possible for user-defined papers. Predefined papers cannot be
modified.
Proceed as follows:
1. If paper disruptions should occur during the print job, cancel the print job by pressing
the <Stop> button.
2. Remove the top sheet of paper from the input tray.