Oce VarioPrint 5000, Operating Manual

Page: 245 / 360

7.3.3 Replace paper cleaning plate
A29246-X17-X-4-7680 / do701.fm
235
7.3.3 Replace paper cleaning plate
The paper cleaning plate should be replaced when it is damaged or worn out. You can tell
when it is damaged or worn out
• when there are frequent paper jams in the area of the fuser station (e.g.: error messages
PM037430/ PM037630) or
• when undesired streaks appear in the print image in the paper-run direction in the area of
the paper cleaning plate.
There is no sheet counter for paper cleaning plates.
7.3.3.1 Remove paper cleaning plate
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C during operation. If you touch them, you may burn yourself.
Allow the fuser station to cool down approx. 1/2 hour before starting work.
Proceed as follows:
1. Open the center doors.
Caution
If you pull out the fuser station too sharply and quickly, you could pull it beyond its
stop point causing it to drop to the floor. There is danger of injury to you and of
damage to the fuser station.
Always slide the fuser station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).