Oce 3275, User Manual

Page: 310 / 340

15-6 Maintenance & Supplies
Maintenance & Supplies
Loading Paper (continued)
Loading Tabbed Sheets in Large Capacity Input (8.5x11, 11x17)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not
front) of the tray. The tab extension width should be 0.5" (12.5 mm) or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key operator mode; otherwise mishandled paper may occur. See p. 14-24 to p. 14-25.
The top sheet is designated face up as the first tab of the finished set. Subsequent offset
tab sheets follow in sequence.
Section 1
Introducttion
3rd TABS
2nd TABS
1st TABS
3 FINISHED SETS
ONE FINISHED SET
Example (LT-401): 9 Tabbed sheets loaded in position for 3 finished sets.
Example (LT-401): 3 Tabbed sheets loaded in position for one finished set.
Section 1
Introduction
3rd TAB
2nd TAB
1st TAB
Printed
side
Printed
side
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
1st TAB 2nd TAB
3rd TAB
2nd TAB
3rd TAB
Section 1
Introduction
1st TAB
Rear
Front
Rear
Front