User’s Guide Océ CS9160 printer
Chapter 3 : Installing the Unit
30
AP-40790 – Rev 1.0 -4/03/2008,
3.3 POWER CABLES CONNECTIONS
Important
•
Make sure to use the supplied power cables. Use of different cables may result in an electric shock or
fire.
•
Do not use damaged power cables. Doing so may result in an electric shock or fire.
•
The printer its disconnect device is the plugs on the power cables.
Important
•
Do not attempt to plug in electrical plugs with wet hands. Doing so may result in an electric
shock.
•
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise, an electric shock or
fire may occur.
•
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not put many loads
on one electrical outlet. Otherwise, heat may be generated, causing fire.
•
Be sure to use an outlet with an earth terminal, and to use the terminal correctly. Otherwise,
electric shock or fire may occur.
•
Do not connect earth cables to :
o
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightning rods. Doing so may cause a large flow of
voltage if lightning occurs.
o
Water pipes or faucets. If there is a plastic part in the pipe, the grounding will not work
correctly.
Caution
•
Follow the instructions below when handling the power plugs. Otherwise, fire may occur.
o
Wipe away dust and any other residue before inserting the plugs.
o
Ensure that the plugs are firmly inserted as far as it will go.
•
Ensure that the plugs have been disconnected from the power sockets when they are not used
for a long time.
•
Earth wires must be connected to wires or terminals that fulfil the following conditions :
•
Power sockets with earth terminals.
•
Earth wires with copper, at least 650 mm under the ground.
Caution
•
Be careful when handling the power cables :
o
Do not make any modifications to the power cables.
o
Do not place anything heavy on the power cables.
o
Do not bend, twist, or pull the cables.
o
Do not wire the cables near equipment that generates heat.
Notes
•
When the power supply of the printer is ON, do not pull out the power cables from the socket.
Whenever the plugs are pulled out from the socket, allow one minute or more before inserting the plugs
in the sockets again.
•
Contact the retail outlet of purchase, when the earth connection cannot be established, or when the
earth connection is not given.
