Navigation
7.
Navigation
7.1 Before Powering Up
1.
Confirm that that battery is properly installed and locked
2.
Confirm that the probe is properly installed
3.
Confirm that the device is tightly secured on the stand (if applicable).
7.2 Powering On
To turn on the device, press the “POWER” key. Once turned on, the device will automatically check
t h e battery level, printer, probe connection, memory capacity and screen. The screen show in Figure
7-1 will display after the device is turn on
Note: Once the device self-checks successfully, the system will enter its main system screen. If any of
the items fails during self-checking, an alarm will alert you. If the alarm sounds, press direction key
before entering the main system. If the printer fails, it will not influence your measurements
Self-check displays:
Battery Checking.…..OK
This means your battery is good and connected properly.
Probe Checking……..OK
This means the probe is connected correctly and ready to use.
Printer Checking…….OK
This means the printer is ready to print.
Storage…………………..100%
Percent represents the remaining storage space.
Note: If “Disconnect” is displayed instead of “OK” next to the probe-checking, remove and reconnect
the probe. If “Disconnect” is still displayed, check the probe cord and contact Life Systems, Inc.
Figure 7-1
Power On Screen
Page
18
