029 2085 8200
4
SUPPLY & EXTRACT VENTILATION UNIT
WITH HEAT RECOVERY
INSTALLATION, OPERATING & MAINTENANCE
INSTRUCTIONS
The EMC Directive
2004/108/EC
The Low Voltage
Directive 2006/95/EC
CODE DESCRIPTION: MATCHED COMBINED ATTENUATOR
XBC 25 - HS - MS10
|
|
|
|
1
2
3
4
1. XBOXER XBC Range
2. Unit Size 10, 15, 25, 45, 55 and 65
3. HS = Horizontal Supply/Discharge unit
or HE = Horozontal Extract/Intake unit
4. Attenuator MS10 = 1050 mm; MS12 = 1250 mm;
MS16 = 1600 mm
CODE DESCRIPTION: XBOXER XBC VENTILATION UNIT
XBC 45 - H - LCO - R - BA
|
|
|
| |
|
|
1
2
3
4 5
6
7
1. XBOXER XBC Range
2. Unit size 10, 15, 25, 45, 55 and 65
3. H = Horizontal Side by Side layout
4. E = Electric Heater; L = LPHW Heater, N = No Heater
5. CO = Ecosmart Connect Control
CL = Ecosmart Connect Control with Legacy Sensor Support
6. R = Opposite arrangement, (refer to page 3)
7. BA = Bottom access (filters only, refer to page 3)
Figure 1: Layout Overview of the XBC unit viewed from above and shown
with matched room side and atmospheric side attenuators.
Access for maintenance and inspection of the standard XBOXER XBC units
is from the side of the unit.
Access to Extract Filter / Fan
*
Access to Coil bleed and drain /
Valve / Valve Actuator /
Electric Heater Elements
Access to Controls
XBC Unit
Room Side Extract / Supply Attenuator:
1050 / 1250 / 1600mm long (optional)
Atmospheric side Intake / Discharge Attenuator:
1050 / 1250 / 1600 mm long (optional)
Duct Connection
Blanking Panel
Access to Intake Filter /
Fan / Condensate tray
and Pump
*
Attenuator/Flange
connector
Attenuator/Flange
connector
CODE DESCRIPTION: XBC UNITS WITH WEATHER ROOF
XBC 15 - H - LCOWP
Unit Size 10, 15, 25, 45, 55 and 65
WP = Fan Unit supplied with Weather Roof
INTRODUCTION - XBOXER XBC
ECOSMART (CO) MODELS
The information contained in this document provides details of
installation, operation and maintenance for installers and users of the
XBOXER XBC Supply and Extract Ventilation Unit with Heat Recovery.
This supply and extract air handling unit range comprises a combination
of high efficiency centrifugal fans with EC motors, a counterflow design
plate heat exchanger, filters, optional heaters (LPHW and Electric) and a
casing with high mass acoustic treatment.
A range of matched, close coupled attenuators with a similar construction
method to that of the unit is available. The attenuators can be flipped for
positioning on the left or right of the fan unit (see fig 1) allowing flexibilty
for duct layout.
Attenuators are available in 1050, 1250 and 1600mm lengths and a
matching attenuator flange is attached to the fan unit.
General information regarding performance and specifications for the
equipment may be obtained from our Technical Literature, and/or project
specific documentation.
XBOXER XBC
ECOSMART (CO) MODELS
*
Note: On bottom access units (BA) Filters cannot be accessed from the side of the unit.
Summary of Contents for ecosmart CONNECT XBOXER XBC
