22
Novell Business Continuity Clustering 1.1 for NetWare Administration Guide
no
vd
ocx (
e
n)
1
1
Decemb
er
2
007
The same installation program used to install the Identity Manager engine is also used to install the
Identity Manager drivers and management utilities. See
Installing Identity Manager on NetWare
(http://www.novell.com/documentation/dirxml20/admin/data/abaa2oj.html)
in the
Novell Nsure
Identity Manager 2.0.1 Administration Guide
.
NOTE:
The IDM 2.0.1 documentation also applies to IDM 2.0.2.
The Identity Manager (IDM) 2.0.2 engine and eDirectory driver (or later version of IDM 2.x) must
be installed on one node in each cluster. The node where the Identity Manager engine and eDirectory
driver is installed must have an eDirectory replica with at least read/write access to all eDirectory
objects that will be synchronized between clusters (see the list in the
Important
reminder below).
This does not apply to all eDirectory objects in the tree.
The IDM 2.0.2 management utilities must also be installed, and can be installed on a cluster node,
but installing them on a non-cluster node is the recommended configuration. The management
utilities should be installed on the same server as iManager. See
“Business Continuity Cluster
Component Locations” on page 25
for specific information on where to install IDM components.
NOTE:
Filtered eDirectory replicas are not supported with this version of Business Continuity
Cluster software. Full replicas are required.
IMPORTANT:
The eDirectory replica must have at least read/write access to the following
containers:
The Identity Manager driver set container.
The container where the Cluster object resides.
The container where the Server objects reside.
If server objects reside in multiple containers, this must be a container high enough in the tree
to be above all containers that contain server objects.
Best practice is to have all server objects in one container.
The container where the cluster pool and volume objects will be placed when they are
synchronized to this cluster. This container is referred to as the landing zone. The NCP server
objects for the virtual server of a BCC enabled resource will also be placed in the landing zone.
If the eDirectory replica does not have read/write access to the containers listed above,
synchronization will not work properly.
Installing Identity Manager 3 Bundle Edition
IDM 3.0.1 is supported with BCC 1.1 Support Pack 1 and is included with the IDM 3.0.1 Bundle
Edition. Instructions for installing and configuring the IDM 3.0.1 Bundle Edition can be found with
the
IDM 3.0.1 Bundle Edition Documentation (http://www.novell.com/documentation/oes/implgde/
index.html?page=/documentation/oes/implgde/data/b4dgr2g.html#b4dgr2k)
.
