ID50 Series Panel - Installation, Commissioning & Configuration Manual
Appendix 1 - S
pecifications
A1 - 1
997-263, Issue 4
September 2002
Appendix 1 - Specification
ID50 Series Panel
General:
This fire control panel is designed to comply with the
requirements of EN 54 Part 2/4: 1997. In addition to the basic
requirements of EN 54-2, the panel may be configured to
conform with the following optional functions - the applicable
clauses of EN 54-2 are referenced as follows:
Options
Clause
Indications:
Fault signals from points
8.3
Recording of the number of entries
into fire alarm condition
7.13
Controls:
Coincidence detection
7.12
Delay of the immediate actioning of outputs
7.11
Disablement of each address point
9.5
Test condition
10
Outputs:
Fire alarm device(s) (Sounders)
7.8
Fire alarm routing equipment
7.9
Fire protection equipment
7.10
Fault warning routing equipment
8.9
(requires monitoring by fault routing equipment)
This panel complies with the European Low Voltage Directive
73/23/EEC (and the amending Directive 93/68/EEC), by the
application of the safety standard EN 60950.
The panel conforms with the essential protection requirements
of the EMC Directive 89/336/EEC (and the amending Directives
92/31/EEC and 93/68/EEC), by the application of EN 50081-1
(emissions) and EN 50130-4 (immunity).
Mechanical:
Construction:
Sheet steel enclosure carries all
displays and controls under a steel
sheet cover.
Dimensions (mm):
365(h) x 380(w) x 110(d)
Approx Weight
Back Box:
6kg (no batteries)
