Appendix A: Quick Reference Guide
N-1000-III/IV
N-1000-III/IV
N-1000-III/IV
N-1000-III/IV
N-1000-III/IV
A–3
Parameter
User Response
durA
duration of time as shown below:
{S_sec | M_min | H_hr} where
sec= seconds (1–63)
min= minutes (1–63)
hr= hours (1–63)
dr1
relay that is pulsed when a duress status is received from
Reader 1
dr2
relay that is pulsed when a duress status is received from
Reader 2
errors
error count (0–255)
fsn
format slot number (1–8)
format
format command parameters for a specific card reader
and/or cards (see F command)
group
group number (1–32)
h1
start time zone: hours (00–23)
h2
end time zone: hours (00–23)
hol
holiday number (1–32)
input
input number (1–16) are hardwire Panel/System alarms
(N-1000-II)
(N-1000-III/IV)
17 com status 20 mA
17 com status 485–20 mA
18 aux status 232 port
18 aux status 232 port
19 primary power
20 tamper
21 input ground fault status
22 low power supply
23 external 5 volt short
99 reset
i/o
This symbol actually stands for
{
I_#,O_#,G_#
}
and
indicates that you must choose one
Input
,
Output
, or
Group
. Refer to individual parameter for details.
limit
maximum use limit
m1
start time zone: minutes (00–59)
m2
end time zone: minutes (00–59)
mm
month number (1–12)
nh
card numb mode time (1-65535 units) where each unit
equals 15 seconds. And where once a valid card is read,
it will not read on any other reader connected to this
panel. Card numb duration is cleared at midnight (00:00)
nn
a two digit number between 16 and 64 that indicates the
number of characters to skip after the beginning of the
access code number