42 Chapter 2 WAN Adapter Modules
205677-F Rev 00
Installing/Removing WAN Adapter Modules
It is assumed that your unit arrived with the modules already installed. There are
times it may be necessary to remove or install new modules. Use the procedure
below to accomplish this task.
To ensure a proper fit of the WAN module, insert the module so that the back
panel is facing up and is readable.
To install a WAN adapter module:
1
Use a Phillips screwdriver to remove the screw on the blank faceplate
covering the slot(s) you will be using. Save the screw(s), you will need them
later. Pull off the blank faceplate covering the slot. Save the faceplate, you
may need it later.
2
Carefully slide the adapter module into Port 2 or Port 3, located at the lower
right side of the Passport 4460 back panel. Make sure that the module is
pushed all the way in, so it firmly mates with the connector at the rear of the
slot.
Warning:
Do not remove or insert modules while the Passport 4460 is
operating. To do so could result in damage to the Passport 4460 unit.
Caution:
When installing or removing expansion modules, be sure that
the module is inserted properly and does not slip out of its guide. This
could cause damage to either the base module or the adapter module.
Caution:
Use an anti-static wrist strap when handling any module.
Failure to do so could result in damage to the module.
Do not plug in the power cord until all modules and connectors have been
properly installed.
Summary of Contents for Passport 4460
