Nordson Vulcan Jet, Customer Product Manual

Page: 33 / 172

Installation
3-7
Part 1126187_05
E
2021 Nordson Corporation
S
In some more demanding applications, use the heat exchanger
already installed in your applicator.
S
Supply clean air at a pressure less than 30psi (2bar) via 4mm
high flex tubing.
S
To make the heat exchanger operate, use 1126121 KIT, AIR
FLUSH, HEAT XCH, VULCANJET, found on page 9-10.
Step 3: Connecting the Controller and Air Cables
1. Refer to figure 3-3. Use the part numbers as a reference when
connecting the seven cables.
S
Make sure the main power supply is NOT energized or plugged in.
2. When done, proceed to Step 4, Commissioning the Controller .
1
3
4
5
CONTROLLER BACK
APPLICATOR RIGHT
ROBOT BACK
PNEUMATIC KIT FRONT
2
6
7
1125179
1125180
1125184
1125181
1125182
DB-25, Straight-pin, Male-to-Male I/O Cable
(Customer supplied)
Power
Cable
(Customer supplied)
Figure 3‐3 Cable connections