Nordson RA-16, Customer Product Manual

Page: 16 / 88

Safety
1-8
E 1995 Nordson Corporation
All rights reserved
Issued 11/95
A1EN − 03 − [SF − LIQD] − 3
Do not operate a system that contains malfunctioning components. If a
component malfunctions, turn the system OFF immediately.
S
Disconnect and lock out electrical power. Close and lock out
hydraulic and pneumatic shutoff valves and relieve pressures.
S
Allow only qualified personnel to make repairs. Repair or replace the
malfunctioning component according to instructions provided in its
manual.
Allow only qualified personnel to perform maintenance, troubleshooting,
and repair tasks. Only persons who are properly trained and familiar with
Nordson equipment are permitted to service this equipment.
S
Always wear appropriate protective clothing and use safety devices
when working on this equipment.
S
Follow the recommended maintenance procedures in your equipment
manuals.
S
Do not service or adjust any equipment unless another person trained
in first aid and CPR is present.
S
Disconnect, lock out, and tag electrical power at a disconnect or
breaker in the service line ahead of electrical equipment before
servicing.
S
Relieve air and fluid pressures before servicing equipment. Follow
the specific instructions in this manual.
S
Use only genuine Nordson replacement parts. Using unapproved
parts or making unapproved modifications to equipment may void
agency approvals and create safety hazards.
WARNING: Note the flash point of the cleaning solvent used.
Only use controlled methods and equipment, such as
temperature-controlled or explosion-protected heaters, to heat
cleaning solvent. Observe explosion-prevention regulations
and follow applicable safety instructions.
S
Refer to the MSDS before using solvents to clean this equipment.
The MSDS will provide use, storage, and disposal information about
the solvent. Read this information carefully and follow instructions.
8. Action in the Event of a
System or Component
Malfunction
9. Maintenance and Repair