Nordson Encore LT, Product Manual, Page: 61 / 92

Repair
6-5
Part 1604857-04
E 2014 Nordson Corporation
Cable Replacement
Cable Removal
1. Disconnect the gun cable from the controller.
2. See Figure 6-1. Remove the bottom screw (12) from the housing (9).
3. See Figure 6-6, View A. Loosen the two M3 x 20 screws (12) securing
the handle base (27) to the handle.
4. Pull the base away from the handle enough to free the bottom edge of
the ground pad (15) from the base.
5. Pull the bottom edge of the ground pad out and away from the handle.
6. See Figure 6-6, View B. Remove the M3 x 8 screw, lock washer (16,
17), and ground terminal from the ground pad.
7. Remove the E-ring (30) from the cable.
8. See Figure 6-6, View C. Pull the cable connectors out of the handle.
Disconnect the power supply harness from the gun cable by inserting a
small flat-bladed screw driver in the slot of the power supply harness
connector to release the catch.
9. Carefully disconnect the round trigger connector from the trigger switch
connector.
10. Pull the cable out of the handle base, feeding the connectors through
the base one at a time.
15
12
27
30
16
15
Trigger
Power Supply
Ground
VIEW A
VIEW B
VIEW C
17
Figure 6-6 Cable Replacement
12. M3 x 20 screws
15. Ground pad 16. M3 x 6 screw
17. Lock washer 27. Handle base
30. E-ring