Nordson Encore LT, Product Manual

Page: 60 / 92

Repair
6-4
Part 1604857-04
E 2014 Nordson Corporation
Powder Path Installation
1. See Figure 6-4. Install the outlet tube (4) into the gun body (13), with the
end of the tube flush with the end of the gun.
2. Install the inlet tube (25) into the handle (24), then install the end of the
tube into the handle base (27).
3. Push the handle base close to the handle, then hook the top end of the
ground pad (15) into the body and rotate it onto the handle. Make sure
the cable wires are not pinched or trapped during re-assembly.
4. Install the handle base onto the handle and ground pad and secure it
with the two M3 x 20 screws (12).
5. Install the elbow onto the inlet tube, with the end oriented toward the
front of the gun as shown.
Gun Re-Assembly
1. See Figure 6-5. Align the gun body with the handle and slide them
together, engaging the internal ribs of the gun body with the handle tabs.
NOTE: Make sure that the power supply harness is not pinched between
the bulkhead and the power supply.
Internal Ribs
Handle Tabs
Elbow
Figure 6-5 Installing the Gun Body on the Handle
2. Insert your finger into the outlet tube at the front of the gun and align the
inside end of the tube with the elbow, then push on the tube to seat it in
the elbow.
3. Connect the power supply harness to the gun cable, then tuck both
through the bottom hole in the bulkhead, into the gun body.
4. See Figure 6-1. Install the cover, housing, and hook as as shown.
5. Install the electrode assembly (3) into the front of the gun body. Make
sure the wire electrode is not bent or broken.
6. Install the nozzle (2) on the electrode assembly, making sure the keys in
the electrode assembly slide into the slots on the nozzle.
7. Install the nozzle nut (1) over the nozzle and rotate clockwise to secure.